Posted by: freesystem | February 27, 2008

BatchPCB: PCB Fabrication for the average hobbyist

I ran across this a while ago while looking for a cheap PCB fabrication place. I was looking at PCBNet with there 25 dollar for two layer deal. Thats kind of a scam, because when I entered my board(which did comply to there requirements), and my board was going to cost 136 dollars. BatchPDB, on the other hand is done my the wonderful people over at SparkFun. Its really cheap even if you only get one board done. There is a ten dollar set up fee(per order) and then an extra $2.50 per square inch. They accept a lot of Gerber formats, most notably Eagle and Protel. They even have a tutorial for exporting the correct gerber from Eagle!

http://www.batchpcb.com

Advertisements

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s

Categories

%d bloggers like this: